Arctic Butterfly® 724 Super Bright Sensor Brush® for cleaning sensor of digital cameras

• Equipped with Bright LED light
• Super-Charged Fiber Technology
• Enhanced fiber cleaning through patented rotary motion
• No canned air - Completely travel safe
• Three Stage Power Button On/Off
• Metal ferrule is attached to the body of the Arctic Butterfly® through a non-conductive joint
• Powered by two (2) AAA batteries (not included)

Now equipped with 2 super bright LEDs Sensor Brush.

The Visible Dust Arctic Butterfly® 724 (Super Bright), Now equipped with 2 super bright LEDs that illuminates the sensor while in operation. This illumination reduces the possibility of fibers being dragged accidentally against the surrounding cavity hence reducing the potential cause of smear usually caused by contaminated fibers. The bright two LED of Arctic Butterfly® 724 makes dust locating an easier task for the sensor cleaning operator.

The DC rotary engine has been modified to meet a certain RPM standard. It generates an optimal centrifugal force that enables speedy dust rejection while increasing the charge enhancement of the fibers.

These combined patented features also include SCF (Super Charged Fibers). By implementing nano-coating technology for charge enhancements and by using super thin fibers for maximum lift capability along the AB-724's rotary motion for cleaning/charging (without the use of canned air) makes the Arctic Butterfly® 724 (Super Bright) a superb sensor cleaning tool.

Because of its safety features all models of Arctic Butterfly® can be safely used on ITO (Indium Tin Oxide) coated sensor and DLSR's with built in sensor cleaning systems.

Requirements

This device requires two (2) AAA batteries (not included).

Instructions

WARNING: Do Not Spin Device While Brush is on Camera´s Sensor

Read complete instructions below before using your spinning device.

1. Requires two (2) AAA batteries (not included). Use high quality batteries for best performance. Remove the batteries before traveling on an airplane.
2. Do not use on camera chamber or parts other than sensor, otherwise you will smear the sensor.
3. Wash inside the cap occasionally with mild soap or in case of a smear.
4. The brush is already inserted into the device, however if the brush comes off (or if you pull it out of the device to wash the brush filaments), you can always attach it back to the device. Do not use glue! The brush is meant to attach to device without glue.
5. When removing the cap, do not pull straight off. Instead, "unscrew the cap following the arrows direction"
6. Turn the device on and spin the brush 3 times for 5 seconds. This will enhance the fiber charges and dislodge any particles within the fibers via centripetal force.
7. Take the Arctic Butterfly® 724 and gently brush across your sensor ONCE. Do not spin the brush while on sensor! Keep your fingers away from the power button on the device while cleaning the sensor to prevent accidental spinning.
   
   
8. Release the camera shutter and proceed with checking the image for evidence of dust particles.
9. Repeat steps 6 through 8 if necessary.